Metal roofs, shingle roofs and honest repairs for Belmont, MS homeowners. Family owned since 2002, and estimates are always free.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Belmont.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Belmont homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Belmont home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Belmont homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
The questions that come up on just about every estimate we write.
A typical Belmont shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Most Belmont houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
For most Belmont homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Often, yes. Plenty of the Belmont roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Sometimes. If the decking is sound and there is only one layer of shingles, a Belmont metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Much less than people expect. Over solid decking with underlayment under it, a Belmont metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Honest words from customers who trusted Roofing Brothers with their roof.
"Second roof they have done for our family. My sister used them first and would not hear of me calling anybody else."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
Our crews cover the surrounding area, not only the city limits.